The battery is the power source of the forklift. The performance of performance will directly affect the use of the battery forklift. During the daily use process, the daily inspection and maintenance of the battery should be strictly in accordance with the standard, and the requirements shall be performed according to the battery maintenance requirements.
This traction truck battery is mainly divided into British BS158 wide series, German standard DIN198 wide series, using tube-type plate research, manufacturing, three charges, so that the battery pack is fully 100% chemical reaction, widely used Domestic imported series electric forklift.
The forklift cell is typically connected in series from a single-single battery of the 2V voltage, called a battery pack. Within the same monobi battery, the negative plate is a total of more than the positive electrode plate. As a positive and negative plate cross-interspentry. Two sides of each positive electrode plate are generated in a chemical reaction, alleviate the deformation of the negative electrode plate, and the arches, and increase capacity. The battery separator is interposed between the positive and negative electrode plates, and there is a plurality of holes that make the electrolyte unobstructed.
The electrolyte is overprincted to damage the electrode plate and the isolation plate and promote the sulfurization of the plate. The electrolyte is too thin, the resistance of the battery increases, and the voltage is rapidly decreased. The potential of the battery is related to the temperature of the electrolyte.
Battery is strictly forbidden during operation, if the water level is lower than the polar plate, it is easy to burn the bleed plate, resulting in a short circuit of the forklift battery, and cannot work properly. Although it has been added in the later stage, the specific gravity of its monomer is not uniform, and there is a signs of vulcanization. The battery storage capacity is reduced, and the use time is shortened. Severely cause the entire set of forklift batteries.
It must be noted that in normal use, the battery cannot be discharged, that is, the travel electric motor and the oil pump motor cannot be simultaneously operated, otherwise the fine sulfuric acid mixed with the active substance into a large crystallization, increase the resistance of the plate. It is difficult to restore it in charging, hinder the charging process.
Forklift drivers should often pay attention to whether the charger is too large, or use the vehicle to excessively discharge, if it is loaded with 1 ton of goods, the motor output current is 70A, and the current output to 120A, may have no use of the motor carbon brush. Increase the output resistance and increase the forklift loading current. Time will be shortened.
Article from: http://www.brcpower.com/
LiFePO4 Battery Manufacturer
Energy storage battery Manufacturer
Integrated machine energy storage battery series Manufacturer
Lead lithium battery Manufacturer
Outdoor Backup Battery Manufacturer
Portable outdoor power supply Manufacturer
Power battery Manufacturer
Powerwall LiFePO4 Battery Manufacturer
Battery rack Manufacturers
Telecom LiFePO4 Battery Manufacturer
Wall mounted battery storage Manufacturer
China Lifepo4 Battery